SMART Board Board 600i5, Конфигурация и руководство пользователя

Страница: 76 / 100

All absolute values you enter must be within the command target range, and all adjustment values
must equal a number within the command target range.
See the following example for adjusting projector brightness:
>get brightness
brightness=55
>set brightness=65
brightness=65
>set bri5
brightness=70
>set brightness-15
brightness=55
Video source specification values
You can use the source input field described in Source selection controls on next page in a command
to set an absolute value or adjustment value to a source other than the active source. You can do this
while the selected source is inactive, but the source device must be connected, or you receive an
invalid command response.
See the following examples, where both an HDMI connector and a VGA1 input are connected:
>set input hdmi
input=hdmi
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58
A P P E N D I X A
Remotely managing your interactive whiteboard system
66