INTRODUCTION
The D300 is a decoding unit that allows
users to access high quality streams directly
from the internet without a PC or classic
computer-based connection. Users can
connect HDMI and composite AV output
devices to the decoder, as well as USB 2.0
transparent peripherals like keyboards and
mice, then easily access streams directly
from the D300 via any stream’s IP address.
HARDWARE INSTALLATION
1. You should have the IP address of your encoder before you start. See the SaviStreamer E300 manual for how to
do this.
2. Connect the RJ45 connector on the D300 decoder to your network with a CAT 5e/6 cable or connect via WIFI.
3. Connect the HDMI connector on the D300 decoder to a display.
4. Optionally connect a USB keyboard & mouse to the D300.
5. Power the D300 decoder with the provided power adapter.
6. Power on the display connected to the D300.
7. Press the power button on the front and wait a few seconds for the D300 to initialize.
8. When you see the Player status screen on the On Screen Display (OSD), use the supplied IR remote control or a
USB keyboard & USB mouse to select Configure in the upper right corner of the screen. (See Figure 1)
9. Once Configure is selected, select Source. Enter the address for your streaming source formatted like the exam-
ple shown in Figure 2. and select OK.
10. Start the E300 encoder and the video stream. See the SaviStreamer E300 manual for how to do this.
FRONT VIEW
REAR VIEW
Figure 1
Figure 2
