RP-2027
ROOM CONTROL PANEL
Doc: 00-12-01, V1.3, 20170201
Page 3 / 4
Copyright © Smallart
®
www.smallart.com.tr
6
General Description
6.1
Error Messages
The error messages for the device are given below;
When the thermostat fails to communicate with the
controller, this error occurs.
When the sensor on the termostat is damaged, this
error occurs.
6.2
Safety Advise
Caution: This device is intended to be used for comfort applications. Where a device failure endangers human
life and/or property, it is the responsibility of the owner, designer and installer to add additional safety devices
to prevent or detect a system failure caused by such a device failure. Ges Teknik or its affiliates cannot be held
liable for any damage caused by such a failure. Failure to follow specifications and local regulations may
endanger life, cause equipment damage and void warranty.
6.3
Mounting Location
Install the room thermostat on an easy accessible interior wall, approx. 1.5 m above the floor in an area of
average temperature.
Keep away from sunlight or other heat sources.
If external temperature sensors are used, room thermostat’s location of mounting is less critical.
6.4
Insatallation
Use the flush mounting box for each application.
6.4.1
Single Device
- Open the mounting hole to its proper place using
a 68 mm holesaw.
6.4.2
Multiple Device
- Specify the centers of holes to be drilled in the
wall. Distance of between the centers of holes
should be min. 96 mm.
- Open the mounting hole to wall using a 68 mm
holesaw.