23 |
P a g e
Using your HDMI Loop-Through Splitter
The HDMI Splitter uses 5v from the HDMI signal for power. If you
run into a situation where you would need to power the splitter,
use a USB cable to connect the Splitter to your DP6. Remember to
turn on the USB power output from your monitor by going to the
System Menu>USB Power>5V.
For further demonstration on how to use your SmallHD HDMI
Loop-‐Through-‐Splitter, go to
http://videos.smallhd.com/smallhd-‐
hdmi-‐splitter-‐demo/
and watch the HDMI Splitter video.
Updating Firmware
The DP6 has the ability to upgrade its firmware based on new
software developments. This is a unique ability of SmallHD
monitors, and is very easy to do. To upgrade:
1 – Format your USB thumb drive to FAT file system
2 – Download the .BIN file from
www.smallhd.com/support
3 – Copy the .BIN file to your thumb drive
4 – Insert the thumb drive into USB Port of the DP6.
5 – Hold down the scroll wheel and then turn the DP6 on.
6 – On screen instructions will inform when the process is
complete.
7 – If your DP6 gets stuck in the Verifying mode, it is safe to turn it
off after a few minutes.
For a demonstration, go to
http://videos.smallhd.com/upgrading-‐
software/
and watch the Upgrading Software video.
Содержание DP6-SDI
Страница 1: ...0 DP6 SLR DP6 SDI User Manual...
Страница 6: ...5 P a g e DP6 Diagram...
Страница 28: ...27 P a g e...
