SMA SB3.0-1AV-41, Руководство по эксплуатации

Страница: 68 / 112

8 Operation SMA Solar Technology AG
Operating manual SBxx-1AV-41-BE-en-12 68
8.18 Saving the Configuration in a File
You can save the current configuration of the inverter in a file. You can use this file as a data
backup for this inverter and then import this file into this inverter again or another inverter from the
same type or device family to configure the inverter. When saving, only the device parameters will
be saved, not any passwords.
Procedure:
1. Activate the user interface (see Section 8.1, page 50).
2. Log into the user interface (see Section 8.2, page 54).
3. Select the menu
Device Configuration .
4. Select [ Settings ].
5. In the context menu, select [ Saving the configuration in a file ].
6. Follow the instructions in the dialog.
8.19 Adopting a Configuration from a File
To configure the inverter, you can adopt the configuration from a file. To be able to do this, you
must first save the configuration of another inverter from the same type or device family in a file (see
Section 8.18 "Saving the Configuration in a File", page 68). When saving, only the device
parameters will be adopted, not any passwords.
Requirements:
☐ Changes to grid-relevant parameters must be approved by the responsible grid operator.
☐ The SMA Grid Guard code must be available (see "Application for SMA Grid Guard Code"
at www.SMA-Solar.com).
Procedure:
1. Open the user interface (see Section 8.1, page 50).
2. Log into the user interface as an
Installer (see Section 8.2, page 54).
3. Select the menu Device Configuration .
4. Select [ Settings ].
5. In the context menu, select [ Adopting the configuration from a file ].
6. Follow the instructions in the dialog.
8.20 Updating the Firmware
If no automatic update is set in the communication product (e.g. SMA Data Manager or
Sunny Home Manager) or in Sunny Portal, you have the option of carrying out a manual firmware
update.
You have the following options to update the firmware:
• Update the firmware with the existing update file via the user interface of the inverter.