SMA CLCON-10, Руководство по установке

Страница: 59 / 86

Pin group Relay Pin Signal Explanation
Digital output 3 C B1 NC Back contact
B2 CO Change-over con-
tact
B3 NO Front contact
Procedure:
1. Connect the connection cable to the remote terminal (see the manual from manufacturer). Trim
the unneeded insulated conductors up to the cable shield and note down the conductor colors.
2. Connect the connection cable to the six-pole plug:
• Depending on the remote terminal and the pin assignment of the pin group, identify the
conductor entries that are required for connecting the connection cable.
• Release the required conductor entries using a screwdriver and insert the insulated
conductors into the conductor entries. Observe the pin assignment.
3. Insert the six-pole plug at terminal X2 into pin row A or B .
4. On the connection cable, mark the terminal and the pin row to which the connection cable is
assigned. Use the supplied cable tie with caption field.
5. Write down the terminal assignment on the supplied supplementary sheet.
6.12.5.3 Connecting a Remote Terminal for Feedback via Analog Signal
Via the pin groups Analog current output 1 , Analog current output 2 , and Analog current
output 3 of terminal X6 you can give the grid operator feedback, for example, if and which
specifications for the grid management services are currently implemented in the system. Which
feedback options were set at the factory for terminal
X6 and its pin groups, is described in a
previous section (see Section 6.2, page 26). The feedback options that you can choose from can
be found in the menu
Settings on the user interface of the Cluster Controller.
Requirements:
☐ The remote terminal must be technically suitable for connection to the analog outputs (see
Section 9, page 78).
☐ The connection cable must be prepared for connection to the multipole plug (see Section 6.5,
page 30).
6 Connection and Commissioning SMA Solar Technology AG
Installation Manual 59 ClusterController-IA-en-15