SMA CLCON-10, Руководство по установке

Страница: 30 / 86

Procedure:
1. Insert one of the coding tabs on the coding
element, parallel to the conductor axis, into the
pin to be coded.
2. Remove the coding tab from the coding element
by snapping it off.
3. On the multipole plug, remove the key from the
conductor entry that will receive the coded pin
when connected to the Cluster Controller.
6.5 Preparing Connection Cables for Connection to
Multipole Plugs
Always proceed as follows to prepare connection cables for connection to multipole plugs.
1. Strip 40 mm of cable sheath from the end of the connection cable to which the multipole plug
is to be attached.
2. Perform the following additional steps for the connection cables for the analog inputs, the
analog outputs and the temperature inputs:
• Trim the cable shield of the connection cable to 15 mm.
• Fold the surplus cable shield back over the
cable sheath.
6 Connection and Commissioning SMA Solar Technology AG
Installation Manual ClusterController-IA-en-15 30