SMA CLCON-10, Руководство по установке

Страница: 54 / 86

Figure 22: Transmission of digital signals for active power limitation to two Cluster Controllers via relays K1 and
K2 of a ripple control receiver (example)
6.12.3 Analog Setpoint Signal
6.12.3.1 Connecting a Signal Source to an Analog Input for Active
Power Limitation
Analog signals for active power limitation are transmitted to the pin group Analog current input 2
in terminal X8 on the Cluster Controller. A remote terminal unit can be used as an analog signal
source, for example.
Additionally required material (not included in the scope of delivery):
☐ 1 analog signal source
☐ Connection cable (see Section 6.3 "Cable Requirements", page 28)
Requirements:
☐ The signal source must be technically suitable for connection to the analog inputs (see
Section 9, page 78).
☐ The connection cable must be prepared for connection to the multipole plug (see Section 6.5,
page 30).
6 Connection and Commissioning SMA Solar Technology AG
Installation Manual ClusterController-IA-en-15 54