SMA 800-3PH150, Руководство пользователя

Страница: 1 / 8

Page 1
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your
3-Point Sprayer.
Retain a copy of your receipt for your unit,
as it will be required to validate any warranty service
Products are warranted against manufacturer or workmanship
defects for one year from date of purchase for home owner
usage and 90 days for commercial usage.
For technical assistance, visit our website @
www.fimcoindustries.com or call: TOLL FREE @ 1-800-831-0027
Our Technical Support Representatives will be happy to help you.
To obtain prompt, efficient service, always remember to give the
following information…

Correct Part Description and/or part number

Model #/Serial # of your sprayer
Part descriptions and numbers can be obtained from the illustrated
parts list section(s) of this manual.
OWNER’S MANUAL
Category I or II
Model: 800-3PH150
(5301770)
(150 Gallon 3-Point Sprayer w/Handgun
)
(Boom-Ready)
Assembly Instructions
1. Install the tee valve sub-assembly to the 3-point carrier valve
mount and position as shown in the exploded view.
2. Slip the 1/2” bypass hose (from the relief valve) over the fitting
on the bottom of the tank. Slide the hose clamp to the end of
the hose and secure.
3. Find the 1” x 36” pump feeder hose. Using a good quality
thread sealant, carefully thread the 1” fitting into the strainer
and the 3/4” fitting into the inlet side of the pump. Slip the hose
all the way onto the fittings and secure with the hose clamps.
4. Attach the 3/4” hose coming off the valve assembly to the out-
put side of the pump by threading the 3/4” fitting into the pump
and securing with the hose clamp. Remember to use sealant.
5. The roller pump is NOT included with the assembly. Attach the
adapter, the torque chain and S-hook to a pump as needed. It is
intended for your pump to be mounted directly to the tractor
PTO. The torque chain needs to be secured to the tractor to
keep your pump from spinning.
6. Wrap the handgun hose around the hose hangers which are
attached to the tank straps.
7. Using sealant thread the gauge into the top of the tee valve
assembly.
8. This unit is ready for a boom to be attached to the upright
mounting angles with u-bolts. One, two or three boom feeder
hoses may be used by removing the unused hose and fitting
from the TeeValve and replacing it with a pipe plug (supplied).
Attach the boom feeder hoses to the boom and secure with
hose clamps.
2415 Industrial Dr.—Jonesboro, AR 72401
Phone: 870-935-3291 : Fax: 870-935-5651
[5008036 (01/19)]