Sloan SJS-1450, Инструкция по установке и эксплуатации

Страница: 3 / 8

3
Tools for installation
Drill bits
Electric drill
Phillips screwdriver
Tape measure/ruler
Hammer
STEP 1
Choosing Installation Placement
The installation wall must be at least 0.25”
(6 mm) thick or the wall should be
reinforced before installing the dispenser.
Positioning
the Dispenser
Clearance above the
dispenser top must be
3.5” (10 cm) or more to
be able to use the key
to open and close the
dispenser.
STEP 2
Install the
mounting plate
Use the mounting
plate holes as a guide
for drilling.
When installing onto a
concrete wall or drywall, drill 1” to 1.5”
deep holes using a 1/4” drill bit. Mount
plate with three wall anchors and screws.
For wood walls, drill guide holes using a
1/8” bit and attach plate with three screws.
Before drilling the holes, make sure there
are no pipes or wires
located behind
the wall.
Using double face tape to
install the mounting plate
When the installation area does not allow
drilling, use double face tape to mount the
dispenser by placing the tape on the back
of the mounting plate after is has been
cleaned of dust, dirt, oils and grease with
the alcohol wipe. The wall area must also
be cleaned in this manner. Let both the
wall and mounting plate dry for at least 10
minutes.
Once tape is secured to the mounting
plate, peel the protective paper from the
double face tape and press the plate
firmly to the wall and hold for 10 seconds.
Leave the mounting plate attached to the
wall and allow to dry for 24 hours before
installing the dispenser.
NOTE: Double face tape may not be used to
mount the unit onto a wall with a coated
surface or wallpaper. Double face tape
cannot adhere to a wall with uneven or
rough surface.
INSTALLATION