6
4 Sec.
1x 2 Sec.
auto
OFF
10 Sec.
After inserting the new battery and opening the supply stops, wait 15 seconds, remove and then reinsert the battery.
A
C
B
C
D
IR activation (see page 5). To enter programming
mode place finger on IR-Click (covering bottom
half of sensor) 1 time for 2 seconds and remove,
ORANGE light will come on. Then, place finger 2
times then remove. Light on sensor should blink
RED to indicate programming mode.
Wait until
LED flashes
ORANGE
A
Cover IR-Click (bottom half of
sensor) until LED flashes RED 4
times - hold IR-Click until LED
flashes 1 to 8 times from minimum
to maximum range. See diagram
below. Release when requested
range is reached.
B
D
4 Sec.
1x 2 Sec.
auto
OFF
10 Sec.
4 Sec.
1x 2 Sec.
auto
OFF
10 Sec.
4 Sec.
1x 2 Sec.
auto
OFF
10 Sec.
4 Sec.
1x 2 Sec.
auto
OFF
10 Sec.
4 Sec.
1x 2 Sec.
auto
OFF
10 Sec.
Deactivate
...1x
Activate 12HR
...2x
Activate 24HR
Activate 48HR
...3x
...4x
touch
touch
touch
touch
touch
(bottom half)
1x
2x
3x
4x
5x
7x
8x
6x = factory setting
SENSOR RANGE ADJUSTMENT DIAGRAM
SENSOR RANGE ADJUSTMENT
12/24 LINE PURGE FEATURE
This feature will operate the faucet every 12 or 24 hours since
last use, or if not used, to prevent stagnant water conditions.
Default purge duration is two minutes.
Consult factory regarding other timing options.
Steps to activate purge line feature:
1. Activate IR: cover lower part of sensor window with a white
card/paper until LED flashes ORANGE to confirm program
mode is active.
2. Cover lower part of sensor window once more with a white
card/paper for approximately 24 seconds (ignore LED
indications during this period). Release when requested
program is reached. (See LED indications to right.)
