INSTALLATION INSTRUCTIONS FOR EAF-3X0 SERIES ELECTRONIC,
SENSOR-ACTIVATED LAVATORY FAUCETS
Code No: 0816654
Rev. 5 (07/22)
Faucet Variations
-
ISM
Integral Spout Temperature
Mixer
SLOAN
®
LIMITED WARRANTY SUMMARY
Sloan Valve Company (“Sloan”), warrants its products against defects in materials and workmanship, excluding damage
caused by matters beyond Sloan’s reasonable control. Instructions for filing claims can be found in the Limited Warranty which
can be obtained at
www.Sloan.com
or by requesting a free copy by telephone at 888.756.2614. Sloan will repair or replace
your defective product, or provide a refund, as your exclusive remedy. This is only a general summary of Sloan’s Limited War-
ranty so it is important to note that the specific terms, conditions, limitations and exclusions, including the duration of warranty
coverage for your particular Sloan product, are contained in the actual Sloan Limited Warranty. The Limited Warranty is subject
to applicable laws in your country, state, province or other jurisdiction—and disputes arising under the Limited Warranty are to
be resolved by binding arbitration unless you provide Sloan with an opt-out notice no later than 30 days after your purchase
date. In case of a conflict with this summary, the terms and conditions set forth in the complete Limited Warranty will prevail.
pose of resale. This warranty does not cover the life of batteries.
THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT IS SLOAN VALVE COMPANY RESPONSIBLE FOR ANY
CONSEQUENTIAL DAMAGES OF ANY MEASURE WHATSOEVER.
PRIOR TO INSTALLATION
Prior to installing the Sloan OPTIMA Plus® EAF-3X0 Series
faucets, install the items listed below. Also, refer to rough-in
illustrations.
• Lavatory/sink
• Drain line
• Hot/Cold water supply lines or pre-tempered water supply
line
IMPORTANT:
• ALL PLUMBING SHOULD BE INSTALLED IN ACCORDANCE
WITH APPLICABLE CODES AND REGULATIONS.
• FLUSH ALL WATER LINES PRIOR TO MAKING
CONNECTIONS.
• KEEP THREAD SEALANT OUT OF YOUR WATERWAY TO
PREVENT COMPONENT PART DAMAGE! DO NOT USE ANY
SEALANT ON COMPRESSION FITTINGS.
Trim Plates
When the EAF faucet is installed on a sink that has three (3)
hole punchings, a trim plate should be used.
Trim plates must be
specified and ordered separately.
ETF-312-A Trim Plate for 4” (102 mm) Centerset Sink
ETF-510-A Trim Plate for 8” (203 mm) Centerset Sink
Tools Required for Installation
• 13mm open wrench or nut driver for faucet retainer nut
• 3/4” open end wrench for female end of flex hose
EAF-3X0
EAF-3X0-ISM
