Connecting Slingbox SOLO • Page 8
STEP 3: CONNECT THE REMOTE CONTROL IR CABLE
•
Remove the remote control IR cable from the A/V Pack.
•
Connect the remote control IR cable to the IR connector on the Slingbox.
•
Place the remote control IR cable heads on the top or bottom of your DVR or Cable/Satellite BOX Receiver
so they point at its IR sensor.
Make sure they extend out far enough over the front of the device to send a signal to your Cable Box or Satellite
Receiver. You may want to affix the remote control IR cables using the adhesive pads after installation is
complete.
TIP:
The IR sensor is on the front of your Cable/Satellite box or DVR, usually behind a dark, sometimes reddish
plastic window. If you don’t see the sensor, shine a flashlight through the window and look for a small bulb similar
to the one on the end of the remote control cable.
STEP 4: CONNECT TO YOUR NETWORK
•
Remove the Ethernet cable from the Power/Network Pack.
•
Plug one end of the Ethernet cable into the Slingbox NETWORK connection.
•
Connect the other end to your home network.
•
The Slingbox works with any high-speed Internet connection or broadband home network. You must have
a router to use the Slingbox.
TIP:
If you have multiple routers on your home network, please go to visit
support.slingmedia.com
for
instructions on how to set up the Slingbox on your network.
STEP 5: CONNECT THE POWER SOURCE
•
Remove the power adapter from the Power/Network Pack.
