4.2 Unit mount
1) Take a box from the kit and place it 150-160 cm (4.9-5.2 ft.) from the floor line.
2) Prepare space in the wall that will be used for box setup. Space dimensions are 141×359×58 mm
(5.55×14.13×2.28")
3) Place installation box inside prepared space and fix it.
6) Connect all communication wires and fix the wires cap. Place outdoor station inside the installation
box and fix it by two screws from the bottom side.
Shan
7
8
Flush mount
5. Software setup
Below you can see multi-apartment outdoor panel main screen:
Call:
depending on the outdoor panel mode enter from 4 to 10 figures of the appartment number and
then press # to start calling;
Guard:
enter 0000 on the keyboard then press # to call the guard;
Unlock:
press # then enter unlock code then press # again to unlock the door;
Cancel:
press * any time to delete figures or cancel a call.
Press # twice then enter Admin password (123456 by default) and press # again to enter outdoor panel
settings:
Multi-apartment
outdoor panel
Screws
Installation box
Note:
Do not cover the hole on the bottom side of installation box. This hole is for the moisture removal from
the space between the box and outdoor panel.
Enter number
Call : Appartment No. -> #
Guard: 0000 -> #
Unlock: # -> Password -> #
Cancel: Press *
SIP
Use and buttons on the keyboard to navigate through the menu.
Press # button to enter current menu or change current setting value.
Press * to exit current menu or exit panel settings.
1. Device settings
2. Network settings
3. Access settings
4. Misc settings
5. About system
