Warranty: For the period of one year from date of purchase, manufacturer guarantees that this
Product will meet the specifications when used as directed. Manufacturer’s sole liability and
Customer’s sole remedy under any warranty claim is limited to a Manufacturer’s coupon for a
replacement product upon return of unit and proof of purchase.
QUESTIONS OR COMMENTS: Call
1-888-457-5463
or visit www.slime.com
ITW Global Tire Repair •
125
Venture Drive, Suite
210
, San Luis Obispo, CA
93401
USA
Slime
®
is a
trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.
VACUUM TROUBLESHOOTING:
Vacuum does not turn ON (try one or all of the following):
1. Check the power plug and push it firmly into the receptacle, twist back and forth.
2. Check receptacle and plug terminals for dirt, or debris. (Use a non-conductive probe, not fingers
or metal).
3. Check vehicle power outlet fuse. It should be 15 amps minimum.
4. Check the fuse. It may have blown: 12V fuse is located in the
plug adaptor: unscrew the tip, remove fuse, and inspect.
If necessary, replace fuse with 15A 250V 5mm x 20mm.
Vacuum is not picking up debris (try one or all of the following):
1. There may be an object lodged in the vacuum hose, vacuum accessory tip, or vacuum unit itself.
Unplug from power, remove the vacuum hose and inspect to ensure the unit is clear of blockages.
Check the vacuum accessory tip for blockage. If no blockage is found in the hose or tip, check the unit
itself for blockage. The debris canister should be removed, and the suction port inspected from both
sides. If debris is determined to be stuck in the unit, use a thin flexible item (such as a drinking straw)
to remove it. Do not use sharp objects that could damage the unit.
2. The debris canister may not be correctly seated in unit. Remove the debris canister from unit by
pulling the debris canister straight out, away from the unit. Reinstall the canister into the vacuum
unit by pushing the canister straight into the unit until seated. An audible click will be heard when
the canister is seated properly.
3. The vacuum filter may be dirty, restricting flow. To clean, remove the debris canister from unit by
pulling the debris canister straight out, away from the unit. Open the top lid, and pull out the green
filter retainer. Remove the foam filter from the filter retainer, and rinse both pieces thoroughly with
warm water until clean. Allow parts to fully dry, and reassemble.
FILTER RETAINER
CANISTER