Page 3
7. Attach the 14-pin ribbon cable to the new graphic module,
and slide the module into place.
Make sure the orientation
of the cable is the same as before, as make sure that the
connector is centered on the pins.
8. Verify correct orientation of pin 1 (red stripe) on each end
of the cable. Also make sure the cable is arranged as
shown, such that it does not obstruct the mounting hole in
the board.
9. Attach the jumper lead by sliding the connector down onto
the pin.
10. Reinsert the lens in the front of the case. Make sure it is
centered, and resting between the two small plastic stops on
either side of the window. Before installing the top of the
case,
make sure that the cables are clear
from the two
holes in the front of the circuit board. These holes line up
with the mounting posts in the top of the case. Push the
cables a little to the side if they are in the way.
11. Carefully install the top of the case, making sure that the
display module and the lens fit into the tabs in the top of the
case. Hold the two halves of the case together while turning
the unit over to install the screws.
Do not over tighten the
screws!
They only require a small amount of torque.
All Done
