KJB Security | www.mysleuthgear.com | 800-590-4272 | Find us on Facebook at facebook/sleuthgear and on twitter @sleuthgear
5
e. Insert the memory card securely back into the slot on the camera
f. It is recommended that the camera be power cycled one time after setting the time and
date stamp before making recordings.
3. Select the recording mode by moving the switch either left or right (see pg. 9 for picture):
a. M = Motion Detection recording
b. C = Continuous recording
Using Your Camera
1. Plug the camera into any compatible wall outlet in the desired surveillance area. It will
immediately power on and begin to boot. Boot time is approximately 3 seconds, during which
the internal red LED light will remain lit and is visible near the memory card slot.
2. Once booted, the camera will enter the selected recording mode, confirmed by the following
internal LED status indicators, which can be seen near the memory card slot:
a. Flashing Red
– the camera is recording in Continuous mode
b. Flashing Green
– the camera is recording in Motion Detection mode
c. No Lights
– the camera is in motion Detection mode, but no motion is detected
3. In either mode, video will be recorded and saved as video files onto the memory card and will
over-write the oldest files, one at a time, once the memory card has reached its full capacity:
a. Continuous
– Recording will be constant and saved in 5-minute long files for quick
and easy review and backup.
b. Motion Detection
– Once the camera has detected motion, recording will begin.
Recording will continue as long as motion is detected, but will stop 30 seconds after
motion is no longer detected. If motion is detected for more than 5 minutes, the file will
be saved and a new file started; this process will repeat as long as motion continues
to be detected. The files in this mode will vary from 30 seconds up to 5 minutes.
