SLEIPNER MOTOR AS SIDE-POWER PJC-322, Инструкция по установке и эксплуатации

Страница: 4 / 8

4
PJC-212
1.0.0- 2010
MENU SYSTEM:
Access menu system by pressing menu button
EMERGENCY STOP:
When the STOP button is pressed, the hydraulic dump valve will activate and the
thrusters will stop. On systems with two oil tanks, dump valves on both tanks will
activate and all thrusters will stop.
The EMERGENCY STOP ACTIVATED sybol will be shown on the display. In addition red
LEDs on both sides of the panel will blink and the external buzzer is activated.
NB: FOR EMERGENCY STOP ONLY!
Press STOP again to reactivate the hydraulic system.
The external buzzer can be muted by pressing the button under the loud-
speaker symbol.
SETTINGS
The menu system contains of 5 settings:
1 - Cooling Pump
2 - Pump Settings
3 - Language
4 - Display Settings
5 - Automatic OFF time
Select settings
Ends settings
Chooses function
1/5 Cooling Pump
The cooling pump can be set to “always ON” or “Automatic”.
When the option “Automatic” is selected, the cooling pump will start when oil tem-
perature exceeds 50oC and stop when the oil temperature goes below 40oC.
On systems with two oil tanks, this setting will apply to both tanks.
2/5 Pump Settings
Use to choose between Pump 1 or Pump 2 and select by pressing .
When a pump is choosen, switch between available settings with .
Use to save settings.
PUMP 1 (PTO-mounted): Pump can only be set to OFF or ON
PUMP 2 (PTO-mounted): Pump can be set to ON or AUTO
When pump 2 is set to AUTO and an SPS stabilizer is active, the pump will start
when oil pressure goes below 80 Bar and run for 15 minutes or when a thruster is
running.
When an SPS Stabilizer is not active, Pump 2 will always run. AUTO is used when
the SPS stabilizer is installed to save fuel/energy while the stabilizer system is run-
ning. On systems with two oil tanks, the settings will apply for both tanks.
NB: “Pump 2: AUTO” must only be used on PHC 024 with firmware v.1.008
or newer!