Properly connect your MC.2 by using the supplied wire harness. Connect
the RED wire to a +12v ignition source by using the supplied wire connec
-
tors. Connect the YELLOW wire direct to a +12v battery source by using the
supplied wire connectors.
DO NOT REMOVE THE INSTALLED 10A FUSE!!
Use the
supplied ring terminal to ground the BLACK wire to your vehicle chassis.
(Optional) Connect the ORANGE wire using the supplied wire connectors to
a +12v switched headlight dimming source. (see fig.1)
fig. 1
fig. 2
Using the supplied self-tapping screws
fasten the included receiver mounting
bracket in a safe location away from
heat or any moving components. The
MC.R receiver is water tight and can be
mounted on the frame rail or near your
valve location. Clip the MC.R into the
mounting bracket. (see fig.2) Connect
the 16-pin connector to your receiver and
connect the 3.5mm audio plug from your
MC.2 hand unit to your MC.R.
2
