3
2. INSERTING THE DELTA CLIPS:
• Layout your NINJALINE™ line, note the sewn in DELTA CLIP 1 ½ inch (38 mm) SLEEVES, these are where you
can insert and attach your obstacles.
• DO NOT ATTACH YOUR OBSTACLES ANYWHERE OUTSIDE THE SEWN IN SLEEVES.
• DO NOT MODIFY YOUR NINJALINE OR OBSTACLES, USE ONLY b4Adventure NINJALINE™ Parts.
• Attach your obstacles keeping in mind the reach length your users will have. You may have to do several different
“layouts” to have a workable course. Note: Do not remove Delta Clips when the line is under tension as you may
damage your line.
• To open the Delta clip simply twist open the locking portion of the clip. (Figure 1) Insert the clip into the desired
NINJALINE™, sewn line sleeve. Twist to close clip.
3. NINJALINE
™
SET UP
• Make sure the SLACKERS logo is FACE UP.
• Take Ratchet Line: wrap around tree and tighten (Figure 2). TIP: to keep you line flat, pinch the line to form a
U-shape section where it feeds through the looped end (Figure 3).
• Take Slackline walking line and wrap around the opposite tree and tighten keeping line flat and not twisted
(Figure 4).
4. TIGHTENING THE NINJALINE
™
• Make sure that the ratchet is positioned so that the handle is facing down and the ratchet is fully open (open slot
on axle should be facing up). Then, feed the end of the Slackline through the top of the ratchet (Figure 5).
• Taking up ALL the slack, make sure that the line is not twisted. YOU MUST PULL THE LINE TIGHT BEFORE
USING THE RATCHET (Figure 6).
• Once line is pulled tight, start ratcheting by moving the handle back and forth until you cannot pull any tighter and
the handle is stationary. The ratchet should be underneath the line when complete, and your line should be tight
(Figure 7).
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 1
Correct
Incorrect
Incorrect
b4Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
[email protected] · www.b4adventure.com - DC:080818
