• Never attach the traverse ring to a carabiner. Traverse ring must be pulled directly over the belt.
Fixing of the traverse ring must be done before tensioning the Ninjaline.
Gliding with the traverse ring is only possible between two obstacles.
• ALWAYS attach the Ninja bar holds to two safety carabiners, NEVER to one safety carabiner.
NINJA OBSTACLE CLIPS:
Your set may include additional clips that can be used to extend the play
area on the NINJALINE™ by adding more obstacles on the ends of the line, outside of where pockets
are sewn. See below for instructions on how to attach your obstacles using the Ninja Grip Clips.
Figure 1
Correct
Incorrect
Incorrect
STEP 1
Start by feeding the
line through the top
opening of the clip
STEP 2
Make sure the line
is flat inside the clip,
with the opening
facing upward
STEP 3
Pull the line through
the bottom of the clip
to create a U shape
STEP 4
Insert the Delta
carabiner into the
U shape and pull the
line outside the clip
taut.
NINJALINE™ SET UP
• Make sure the NINJA LINE™ logo is FACE UP.
• Take Ratchet Line: wrap around tree with the smaller diameter and pull the ratchet through the end
of the loop (Figure 2). TIP: to keep you line flat, pinch the line to form a U-shape section where it
feeds through the looped end (Figure 3). Pull the ratchet to tighten the line.
• Take NINJA LINE™ walking line and wrap around the opposite tree and tighten keeping line flat and
not twisted. Pull the line completely through the loop end (Figure 4).
Figure 2
Figure 3
Figure 4
