Skyworth SKW-T21, Руководство пользователя

Страница: 16 / 30

6.6 EPG (Electronic Programme Guide)
The Electronic Programme Guide is a very useful function that allows you to view event schedules
and programme information and to mark events/movies for wakeup of the receiver. To access the
EPG, press
EPG
in viewing mode. Use
pq
to select a channel and
t u
to select an event. Press
OK
to display detailed information of the selected event. Use 9 to quit the detailed information screen.
Press the RED or GREEN buttons to see and select another day. Press the YELLOW button to set a
timer for a selected event. Refer to section
7.3.4
for details of the timer function.
NOTE:
Availability of EPG data depends on broadcast.
6.7 Record, Time shift and Format*
* This part of the user manual describes the full functionality including the recording function and may not be applicable
if the software for recording via USB has not yet been installed and activated. Please, visit our website www.strong.tv to
get more information.
To use these functions, you must connect a USB memory device to the USB port at the rear panel.
For best performance, especially of HD content, we advise to use Hard Disk Drives USB 2.0 or higher.
These must be formatted in FAT32 format otherwise Recording and Timeshift function will not work.
6.7.1 Instant recording*
To immediately record a programme, press
4
to start the recording and press
3
to quit.
6.7.2 Timeshift*
If you want to use the Timeshift function you only need to press 2 in viewing mode. To resume
timeshifted content, press
u
or 2 again. During the playback, you can use the 5 6 or 2 buttons. To
stop the Timeshift mode, press
3
and it will jump to the actual time of the live signal. The function
will still be running in the background and as long you do not switch to another channel it is possible
to jump again to the beginning by pressing
2
again. Also, with t u it is possible to jump in time
during Timeshift modes. Default is set to 20 seconds. Press the
GREEN
Jump Set button to change the
jump time.
If the channel is changed timeshifted content will only be accessible from the newly selected channel.
NOTE:
To switch off the Timeshift function completely you need to change the
Timeshift status to disable in the
Record setup menu.
6.7.3 Timer recording
There are 2 ways to set a timer:
Programming a record timer via the EPG
The easiest way to record an event is via the EPG. Press the
EPG
button to open the EPG, then use
pq to select a channel. After that, press t u and use pq to select an event. You can book a record
12