Skyworks Si57 -EVB Series, Руководство пользователя

Страница: 1 / 34

Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
Rev. 0.2 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • December 14, 2021
Si57x-EVB
Si57
X
/598/599 A
NY
F
REQUENCY
I
2
C P
ROGRAMMABLE
XO/VCXO E
VALUATION
B
OARD
Description
This document describes the operation of the Skyworks
Si57x/598/599 evaluation kit. The Si57x-EVB kit refers
to the evaluation board hardware and software intended
for customer evaluation of the Si57x/598/599 any
frequency I
2
C programmable XO/VCXO. The Si57x-
EVB kit contains the following:
Kit Contents

Hardware

Motherboard (MB)—silkscreen labeled as "Si5xx
Programmable Oscillator"

Daughterboard (DB)—silkscreen labeled as "Si5xx CEB
DB"

Software

Programmable Oscillator Software

Register Programmer

EVB Driver (USBXpress

)
The Si57x motherboard is normally operated together
with a Si57x daughterboard populated with an
Si570/571/598/599. This combination is referred to as
the Si57x-EVB assembly that is also used to evaluate
the Si598/599 any frequency I
2
C programmable
XO/VCXOs. Software is supplied for evaluation of the
Si57x/598/599 device. All Si570 and Si598 XOs are pin
and register compatible. The Si571 and Si599 VCXOs
are pin and register compatible. The Si57x-EVB
supports all configurations of these devices. The
software components run on a USB-equipped PC and
are described in detail in "4. Software Installation" on
page 12.
Note: Si57x/598/599 samples must be ordered separately
from the Si57x-EVB.
Features

Evaluation of Skyworks' Si57x/598/599 any
frequency I
2
C programmable XO/VCXO

Windows-compatible software control and device
programming

Voltage regulator supports at +1.8, +2.5, or +3.3 V

I
2
C communication options are jumper configurable

Voltage control (V
C
) input port (Si571/599)
Quick Start
1. Install an assembled Si57x Daughterboard on to the
Si57x Motherboard.
2. Verify Si57x Motherboard jumper settings are
correct. (The default installation assumes a 3.3V OE
active high DUT. Otherwise refer to Table 3.)
3. Connect the USB cable from the EVB to the host
PC.
4. Install the EVB Driver on the host PC.
5. Install the Programmable Oscillator Software from
the CD or zip file.
6. Launch the Programmable Oscillator Software by
clicking
Start

Programs

Skyworks

Programmable
Oscillator Software
and selecting one of the
applications.
Note: The above instructions assume an assembled daugh -
terboard is available. If it is not available, install the
Si57x/598/599 DUT and place proper output compo -
nents on the daughterboard as described in "1.9. Si57x
Daughterboard" on page 9.