9. Appendix: Typical Waveplots
The plots displayed in this section are provided as an example when measuring signals on this evaluation board with a good lab setup.
These plots were taken using a Keysight Ag DSA90804A 8 GHz bandwidth oscilloscope. A Keysight 5 GHz Ag 1132A differential probe
was used to measure the differential waveforms, and a Keysight N2796A 2 GHz high-impedance FET probe was used to measure the
single-ended waveforms. The signals were measured on the test points located next to each output SMA. The outputs were set up in
the stock configuration of no load capacitor and 0 ohm resistors.
9.1 Differential Clock (DIFF_0) Output (Differential Waveform)
UG337: Si53208-EVB User’s Guide • Appendix: Typical Waveplots
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [email protected] • www.skyworksinc.com
12
Rev. 0.1 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • July 26, 2021
12
