SkyWave SG-7100, Руководство по оборудованию

Страница: 49 / 56

SG-7100 - Hardware Guide
© SkyWave Proprietary 37 T300, Version 01
Note: Remember to leave enough cable slack near the unit for strain relief so as not
to introduce any additional force on the connector. SkyWave recommends
securing the cables during installation.

Route the cable starting from the unit to the power source.
Note: SkyWave recommends that you tape cable ends to prevent dirt from collecting
on the contacts.
3.11 Protect the Cables and Power Connector
CAUTION Cable management and connector strain relief should be
incorporated in the installation. SkyWave highly recommends
securing the cable at regular intervals along its length as part of
the installation to prevent cable wear and eliminate strain on the
power connector.
To protect the unit's power connector, follow the guidelines below:

Secure the cable such that it does not pull on the connector or strain the power
connector.

Tie the cable down so that the weight of a vibrating cable does not stress or strain
the power connection. Use cable ties and tie holders (Figure 36) at 300 to 600
mm intervals along the cable route to prevent chafing, wear, or strain.

Secure the cable tie holder with a self-tapping screw (Figure 36) for best holder
retention.
Figure 36 Cable Management
3.12 Configure and Register the SG-7100
Refer to [ T302 ] to configure the base unit prior to installation.
Adhesive cable tie
holder. Apply a self-
tapping screw here
for added strength.