DMR-200C Installation Guide
The DMR-200C is an Inmarsat D+ mobile satellite communications terminal manufactured by SkyWave Mobile
Communications Inc. SkyWave distributes the DMR-200C through Solution Providers who activate the terminal
on the SkyWave D+ Network and provide application programs that communicate with the terminal.
This manual provides the necessary information to ensure a successful installation of the DMR-200C on a
vehicle, boat or other platform. This manual does not address the DMR-200C’s commissioning procedures as
these procedures vary depending upon the Solution Provider and their specific application.
Configuration Options
The DMR-200C is available in a number of configurations with two standard mounting options.
Part Number Configuration
SM200200-BHX-XXX Bottom Mount Connector
SM200200-SHX-XXX Side Mount Connector
Shipping Box Contents
SkyWave ships the DMR-200C in an individual packaging box with the following parts.
1)
DMR-200C
- qty 1
2)
Installation Instructions - qty 1 (This document)
3)
Mating connector *
- qty 1
* Solution Provider may provide a cable instead of the mating connector.
Tools Required
The following tools are required to install the DMR-200C
1) Drill
2)
5.5 mm drill bit
3)
25 mm hole punch or drill bit (For Bottom Mount Connector version only)
4) Screw
driver
5)
Socket wrench set
Materials Required
The following materials are required to install a DMR-200C. These materials are not included with the DMR-
200C, as they need to be selected for each installation type.
1)
Qty 4 - M5 screws (length depends on mounting surface thickness)
2)
Qty 4 nuts with locking hardware
3)
Water-proof sealing tape
4)
Water-proof sealing compound such as silicone RTV (bottom connector version only)
5)
Qty 1 DMR-200C Cable
