18
1.
2.
Slide an enclosure foam (6) onto the top curved tube (4).
Lay two L-corner tubes(3), the top curved tube(4) and
Repeat steps 1-
2
for remaining three upright sections.
Note: Top curved tube should be curved down.
two middle tubes(5) on the ground as shown. Attach
together using#8 screws(1) one by one, don’t tighten yet.
Scrure the
straight tubes(2) to the middle tubes(5) with #8
screws(1) as
shown. Make sure the two dent sides of the
straight tubes are faced inside as shown.
Tighten all the
#8 screws(1) used in step1 - 2.
Slide two foams(6) onto one side of the assembly.
Note: the location of the small holes in the straight tubes
should be shown as the picture after finishing assembly.
Note:The straight tube(2) will have a dent on the one side
just above the square areas.This is normal.If foam tube is
difficult to slide on, use a little
soapy
water on the inside
of the tube.
6
3. Note: In Step 3 you will secure the Enclosure arches to the frame of the trampoline.
Lift one of the arches assembled in Step 2 and insert the two Straight Tubes (2) into the tops of the two
trampoline frame Square Sockets (M) as shown.
Repeat this procedure to assemble the remaining three arches to the trampoline frame.
Note: Make sure the dent side of the straight tube is against the trampoline frame.
Attach the other arch to the trampoline frame in the
same manner (not shown).
Enclosure Assembly
6
1
1
1
1
3
3
5
5
4
1
2
2
1
The dent sides
90 degrees
