16
17
ASSEMBLY
ASSEMBLY
2.
Leg x6
Self-tapping screw x18
11
3
11
Insert one leg (3) into a big diameter tube of the frame (1) as shown. Then tighten with a self-tapping screw (11) using
the provided screw driver.
Repeat this process until all six legs have been attached to the frame.
3.
Elastic with ball x36
Mat with enclosure net x1
11
6
4
Place the mat with the attached enclosure net (4) inside of
the frame. Align the mat so that the opening of the enclosure
is centered between two legs. Use one elastic with ball (6) to
attach the mat to the frame at the enclosure door (see A).
Attach 5 more elastics with balls using the below drawing
for placement order. (Place in order of A, B, C, D, E, F).
Continue to place the elastics in this even pattern until all 30
elastics with balls have been attached.
To attach the mat to the frame with the elastics with
balls, thread the elastic through the loop on the mat
and pull around the frame. Then loop the elastic
around the ball to hold in place.
Note:
The placement pattern helps keep the mat
centered and the tension on elastics even. If the mat
is not staying centered inside the frame, adjust the
mat by pulling the elastics with balls tight.
After this step is completed, the frame may not lay
flat on the ground. The frame will straighten out with
further assembly
Note:
The balls on the elastics should be facing the
ground as shown to the right.
3
11
1
Opening of enclosure should
be located in the middle
between two legs
Fasten the self-tapping screw with tool
6
4
A
B
C
E
F
D
