www.skywalker-model.com
Entire Contents © Copyright 2010 5 V1.05
Step 17:
Apply the mixed epoxy glue into the carbon-rod slot at
both sides of the bottom wing surface.
Step 18:
Place the
ϕ
4mm carbon-rods (length of 390mm) into
the slots for both sides. Hold the carbon-rods in place
until the epoxy solidified.
Step 19:
Apply the foam double-sided tape (not included) onto
the micro servos.
Step 20:
Install the Z-bended side of steel wires onto the servo
arms for both servos. Enlarge the servo arm holes if
necessary.
Step 21:
Place the two servos into place at the both sides of top
wing surfaces.
