Falcon Flying-Wing Installation Manual
Thank you for purchasing the Falcon flying-wing. Before you start the installation, please
read this manual carefully, so that you may have an overall idea of what to do. In the same
time, please check all parts before you begin. If you find any missing or defective parts,
please contact your local dealer.
1, Required for Installation and Operation:
1.1 Required RC Equipments:
The below RC gears are not included to enjoy your Falcon. They may need to be
purchased separately. For details concerning the equipment listed, please check with your
local hobby shop.
- Minimum 3 channel radio control system for aircraft with transmitter V-mixing function
built-in, or a separated servo V-mixing board
- 2 pieces of 9g micro servos or similar
- AXI 2208 KV1900 out-runner brushless motor or
equivalent
- 18~25A brushless ESC
- APC-LP06040E propeller or equivalent
- 1500~2200mAh 3S lithium-polymer battery pack
1.2 Required Tools and Material for Installation:
- Phillips screwdriver & allen key
- Sharp hobby knife
- Hobby scissors
- Needle nose pliers
- Wire cutters
- Awl
- Marker pen
- Hobby epoxy glue
- Foam double-sided tape
- Fibre tape
- Cable tight
- Male & female velcro tape
2, Assembly Steps:
www.skywalker-model.com
Entire Contents © Copyright 2010 1 V1.05
Step 1:
Trim the plastic canopy with hobby scissors along the
line.
