Step
1
ENCLOSURE POLE ASSEMBLY
WARNING:
Note:
Step
2
Step
3
Step
4
Step
5
New Feature!
2 adults in good physical condition are required for the following assembly.
Wear proper shoes and maintain balance to prevent a fall. Failure to follow
all instructions and warning exactly may result in serious injury.
The lower poles are the poles that are
tapered/narrow at both ends.
Insert push buttons into part F2, the button should pop out
through the hole. You can then attach the lower enclosure poles
to part F2 all the way around the trampoline.
Once the lower pole is attached, insert push buttons in the top
end of the poles. (Make sure the button pops out of the desig-
nated hole.) You can then attach the upper poles to the lower
poles. Attach all the upper poles, making sure the foam
sleeves are covering the poles properly. Place the pole caps
part C on top of the upper poles.
The PVC sleeves should be used to cover all
the poles. Once the upper and lower poles are connected to the
trampoline frame, cover the poles with the PVC sleeves (Part T).
Start connecting the fiberglass rods to each
other by clicking them together, until you
have connected all the rods.
Run the connected fiberglass pieces (from step 3) through the
casing/tubing at the upper edge of the safety net. Continue
through each casing until you form the entire circle, and both
ends of the rods are coming together.
Connect the 2 ends of the rods together with the Rod Connector by sliding them into the
rod connector and ensuring that the extruded parts from the rods click into the holes of the
rod connector
