the temperature differential or “SWING” (1-3). See above for 1-3 “SWING”
temperature valves.
3. To store the “swing number” press the SET button or allow 15 seconds to lapse,
and the new “swing number” will be automatically programmed.
MANUAL CHECK OF “SWING” OR TEMPERATURE DIFFERENTIAL
The operation of the factory set “THERMO SWING” can be checked by adjusting the
SET TEMP 2
℉
above or below the room temperature. This will cause the system to
turn OF or OFF. Normally the system will only respond to temperature changes every
two minutes. Manually changing the SET temperature will activate the system in less
than 10 seconds. IF the “SWING” is changed, then a new room temperature
differential will respond. Factory setting of “SWING” temperature is 2
℉
.
SETTING THE COUNTDOWN TIMER
This remote control system can operate
with a built-in countdown timer when the
transmitter is in the ON or THERMO
modes (
THERMO or ON must be
displayed on the screen
).
1. Press and release the TIME/ TIMER
button on the transmitter. The word
TIMER and 0:15 flash on the screen.
2. Press the UP or DOWN button on the
transmitter to begin advancing through
each of the countdown time options. Available countdown times are 15 minutes,
30 minutes, 45 minutes, 1 hour, 1 hour 30 minutes, 2 hours, 2hours 30 minutes,
and each additional half-hour up to nine hours.
3. To set the TIMER press the
SET
button on the transmitter if the system is ON. It
will remain on until the time has expired. If the system is in the THERMO mode,
it will cycle on and off as the room temperature requires until the “time” has
expired.
OPERATIONAL NOTE:
When the timer is used in the THERMO mode, the
THERMO operation will discontinue when the “time” has expired.
LOW/BATTERY INDICATOR
ROOM
TIMER
FLAME
PM
SET
ON
OFF
THERMO
F
F
