SKY-6601
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
This SKYTECH remote control system was developed to provide a safe, reliable, and
user-friendly remote control system for gas heating appliances. The system can be
operated thermostatically or manually from the transmitter. The system operates on
radio frequencies (RF) within a 20”range using non-directional signals. The system
operates one of 256 security codes that are user programmable; the remote receiver’s
code must be matched to that of the transmitter prior to initial use.
Review
COMMUNICATION SAFETY SECTION
under
TRANSMITTER
section and
THERMO SAFETY SECTION
under
REMOTE RECEIVER
section.
These signal/temperature safety features shut down the fireplace system when a
potentially unsafe condition exists.
The transmitter operates on 2 AAA-size 1.5V
batteries. It is recommended that ALKALINE
batteries always be used for longer battery life and
maximum operational performance.
IMPORTANT:
New or fully charged batteries are
essential for proper operation of the multi-function
transmitter. Insert 2 AAA-size 1.5V batteries into the
battery compartment on the back of the transmitter,
positioning the (+) and (-) ends of the batteries as
indicated on the casing. When the batteries are
inserted, the screen at right (with similar numbers)
will display.
Note:
If a LOW battery icon appears on the
screen, check the position of the batteries; a
reversed battery will not activate transmitter.
Note:
Due to the sensitive
temperature-monitoring components in the
transmitter, it may be necessary to allow the
transmitter to stabilize to room temperature
before accurate room temperatures are displayed on the screen. If the transmitter is
TRANSMITTER
PM
SET
LCD DISPLAY
F
F
ROOM
