___________________________________________________________________________________________________________
Rev. 7/10/15 Page 2 of 6
Skytech: RCAF-LMF-WWS
TO REMOVE THE BATTERIES
1. Remove face from backing plate by insetting a small screwdriver into
the small slot on the side at the top or bottom of the faceplate as shown
to the right then snap OFF.
2. Locate the (2) holders for the 3V button cell batteries.
3. Insert a small screwdriver into the slot at the button cell battery and
pop the battery out (Slots shown in picture above).
4. After the batteries are installed replace the faceplate.
WALL MOUNTING THE TRANSMITTER
1. Remove face from backing plate by insetting a small screwdriver into the
small slot at the top or bottom of the faceplate as shown to the right then snap
OFF.
2. Locate the (2) two mounting holes and mark the holes on the wall. Use the
(2) two dry wall anchors and screws (that are supplied) to mount the base plate
to the wall as shown.
3. The wall transmitter can also be mounted onto an existing (Plastic) electrical
box.
4. Base plate should be mounted level on the wall for best operation.
INSTALLING THE ON/OFF SOLENOID
NOTE: The AFLMF valve kit comes with a brass cap fitting that must be removed before the ON/OFF solenoid can be installed. Under
this brass cap fitting there is a unique safety seal that prevents gas leakage after the brass cap fitting has been removed. This allows
the brass cap fitting to be removed and the ON/OFF solenoid to be installed with out shutting off the main gas valve that supplies gas to
the AFLMF valve kit.
1.
Remove the (2) screws from the front metal faceplate then remove the faceplate on the AFLMF valve kit and set aside.
2.
Using a screwdriver remove the brass cap fitting. Note Figure 1 (Retain the brass cap fitting so if the solenoid is removed
the brass cap fitting can be reinstalled)
3.
Install the ON/OFF solenoid into the threaded hole on the AFLMF that the brass cap fitting was removed from and screw
into place and do not over tighten. NOTE: Figure 2
4.
Replace the AFLMF front faceplate and reinstall the (2) screws and tighten.
5.
Make sure to locate the RED & BLACK wires so they come out the back of the AFLMF to connect to the receiver.
Figure #1
Figure #2
Insert small screwdr
into slot at the top o
and pop cover of
WALL
3V
3V
ON/OFF
Solenoid
Standard
Screwdriver
AFLMF
Valve Assembly
Brass Cap
Fitting
Standard
Screwdriver
AFLMF
Valve Assembly
