___________________________________________________________________________________________________________
Rev. 7/10/15 Page 1 of 6
Skytech: RCAF-LMF-WWS
Model: RCAF-LMF-WWS
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
This SKYTECH remote Wireless Wall Switch system was developed to provide safe, reliable, and user-friendly remote
control system for gas heating appliances. The system can be operated manually from the transmitter. The system
operates on one of 65,536 security codes that are programmed into the transmitter at the factory.
WALL TRANSMITTER
The wall transmitter operates on a (2) 3-volt button cell batteries
(included) made specifically for remote controls and electronic lighters.
Before using the wall transmitter, install the two (2) 3-volt button cell
batteries. Follow instructions below.
The wall transmitter has an ON/OFF rocker switch. When a rocker
switch on the wall transmitter is pressed, a signal light on the wall
transmitter illuminates briefly to verify that a signal has been sent. If the
signal light does not illuminate, check the batteries. Upon initial use,
there may be a delay of five seconds before the remote receiver will
respond to the wall transmitter.
TO INSTALL BATTERIES
1. Remove face from backing plate by insetting a small screwdriver into
the small slot at the top or bottom of the faceplate as shown below then
snap OFF.
2. Locate the (2) holders for the 3V button cell batteries.
3. Place the button cell batteries into the battery holders and snap into
place. (Make sure that the batteries are installed with the (+) plus side as
shown to the right.
4. After the batteries are installed replace the faceplate on the base
.
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO INSTALL OR OPERATE
ON
OFF
Indicator
Light
+
Plus
Side
+
Plus
Side
Insert batteries
into holder and
snap into holder
Insert small screwdriver
into slot and pop out
batteries from holder
