Skytech: FG-105
REV. 2-7-18 Page 2
WARNING
This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely
before attempting installation. Follow instructions carefully during installation. Any modifications of this remote control
or any of its components will void the warranty and may pose a fire hazard.
Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult the gas appliance
manufacturer’s instructions and wiring schematics for proper placement of all wires. All electronic modules are to be
wired to manufacturer’s specifications.
The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/
or electronic module for correct wiring procedures. Improper installation of electric components can cause damage to
electronic module, gas valve and remote receiver.
• With the slide switch in the ON position the system will remain on
until the slide switch is placed in the OFF or REMOTE position.
• With the slide switch in the REMOTE position (centered), the
system will only operate if the remote receiver receives commands
from the transmitter.
• With the slide switch in the OFF position the system is OFF.
• It is suggested that the slide switch be placed in the OFF position
if you will be away from your home for an extended period of time.
Placing the slide switch in the OFF position also functions as a
safety “lock-out” by both turning the system OFF and rendering the
remote receiver inoperative.
Wire Terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
Code Switches
The remote receiver houses the microprocessor that responds to commands from the transmitter to control system
operation. The remote receiver has a 3-position slide switch for selecting the MODE of operation: OFF/REMOTE/ON
NOTE:
This product is designed for use with an attended hearth appliance or fire feature. Adults must be present when
the Control System is operating. DO NOT program or thermostatically set this Control to operate a hearth appliance
or fire feature when Adults are not physically present. Furthermore, DO NOT leave the hearth appliance or fire feature
burning unattended; it may cause damage or serious injury. If an Adult is going to be away from the hearth appliance or
fire feature for any length of time, then the handheld/wall mount, receiver/control module and application should be in the
“OFF” position.
CODE SETTING
CAUTION: All units are shipped from the factory with the code
switch pre-set to the same
codes.
These switches must be re-set to different codes during installation
to prevent interference
from another remote.
Each transmitter can use one of 255 set able security codes. It
WILL be necessary to set the transmitter and receiver code switches
to a matching security code upon initial use. If a replacement
transmitter or receiver is purchased from your dealer or the factory,
the code switches must be set to match the receiver transmitter
code switches. When setting the code switches set the A through
P switch on the transmitter to the same setting as the A through
P switch on the receiver. Then set the 1 through 16 switch on the
transmitter to the same setting as the 1 through 16 switch on the
receiver.
Note:
A small screwdriver can be used to change these code
switches.
Note:
The figure to the right showing the code switches on the
transmitter and receiver.
A
C
E
G
I
K
M
O
1
3
5
7
9
11
13
15
MODEL NO:
A
C
E
G
I
K
M
O
1
3
5
7
9
11
13
15
A
C
E
G
I
K
M
O
1
3
5
7
9
11
13
15
RECEIVER TOP
CODE
SWITCHES
CODE
SWITCHES
TRANSMITTER
BACK
