REV. 12-13-17 Page 3
Skytech: 1420-A
BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter should be at least 12 months.
Check and replace all batteries:
•
Annually.
•
When operating range becomes reduced.
•
When transmissions are not received by the remote receiver.
•
If the hand held transmitter battery measures less than 9.0 volts.
If you encounter problems with your fireplace system, the problem may be with the fireplace itself or it could be with the remote. Review
the fireplace manufacturer’s manual to make sure all connections are made properly. Then check the operation of this remote in the
following manner:
•
Make sure there is a 110-volt power source to the receiver.
•
Check battery in transmitter to make sure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for a tighter fit.
•
Check if the transmitter battery is fully charged.
•
Ensure that the transmitter and receiver are within 20 to 25-foot operating range.
•
If the receiver is installed in a tight enclosed metal surrounding, the operating range will be shortened.
•
Make sure the hand-held transmitter and remote receiver are communicating properly (see LEARNING TRANSMITTER TO
RECEIVER section).
TROUBLE SHOOTING
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODI-
FICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT
For Technical Service, call:
U.S. INQUIRIES
(855) 498-8324 or (260) 459-1703
For Sales: (888) 672-8929
Web site: www.skytechpg.com
CANADIAN INQUIRIES
(877) 472-3923
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to accept the
transmitter security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer or the
factory. In order for the receiver to accept the transmitter security code, be sure the slide button on the receiver is in the REMOTE
(middle) position; the receiver will not LEARN if the slide switch is in the ON or OFF position. The LEARN button in located on the front
face of the receiver; inside the small hole labeled LEARN. Using a small screwdriver or end of a paperclip gently Press and Release
the black LEARN button inside the hole. When you release the LEARN button the receiver will emit an audible “beep”. After the
receiver emits the beep press any transmitter button and release. The receiver will emit several beeps indicating that the transmitter’s
code has been accepted into the receiver.
To delete all of the transmitter codes on your receiver, press and hold the
LEARN
button for 10 seconds. Then you will hear a series of
beeps, indicating that the receiver’s memory has been cleared.
TRANSMITTER WALL CLIP
The transmitter can be hung on a wall using the clip provided.
•
Wood - Drill 1/8’’ pilot holes and install with screws provided.
•
Plaster/Wallboard - Drill 1/4’’ holes, then install with the screws provided.
WALL CLIP
SLOT
WALL CLIP
BATTERY
COMPARTMENT
ON
REMOTE
OFF
Side View
LEARN
Top View
