REV 12/26/07
Page 1 of 6
1410-A
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
This SKYTECH remote control system was developed to provide safe, reliable, and user-friendly remote control system for gas heating
appliances. The remote system is powered by 110-120 VAC, yet only a “dry contact” (no power output).
The system can be operated
manually from the transmitter. The system operates on one of 65,536 security codes that are programmed into the transmitter at the
factory.
TRANSMITTER
The transmitter operates on a 12V (A-23) battery (included). Install the 12V
battery supplied with the unit into the battery compartment.
It is recommended that AKALINE batteries always be used for longer battery life
and maximum operational performance.
The transmitter has ON and OFF functions that are activated by pressing either
button on the face of the transmitter. When a button on the transmitter is
pressed, a signal light on the transmitter illuminates briefly to verify that a signal
has been sent. Upon initial use, there may be a delay of three seconds before
the remote receiver will respond to the transmitter. This is part of the system’s
design. If the signal light does not illuminate, check the position of the
transmitter’s battery.
RECEIVER
RECEIVER
When plugged into a standard 110-120 VAC receptacle, the remote receiver
operates
on commands from the transmitter or from the slide switch on the face
of the receiver
(This switch is to be used during a power outage to operate the
appliance manually).
The remote receiver is manufactured with a “dry contact” relay
in its circuitry that
operates like an on/off switch, however, no power or
current passes from the 110-120
VAC input side to the wires leading from the output
side of the remote receiver.
This 1410 remote control system can be used in simplified installations to
control a millivolt gas valve without any additional relays or components.
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO INSTALL OR OPERATE
ON
OFF
12V
BATTERY
COMPARTMENT
FRONT
BACK
SIGNAL
LIGHT
ON/OFF
BUTTONS
To 120VAC input
Slide
Switch
OFF
REMOTE
ON
LEARN
VALVE
ANTENNA
REMOTE RECEIVER
Dry Contact
(2) 1/4” female
Connectors
