23. Locate and glue shear webs SW1 thru
SW10 in place on the rear of the main spar
as show on the plan. Sand the shear webs
as needed to fit. Insure that the grain is
running vertical.
24. Break off the rear tab that holds the 1/4” sq.
trailing edge piece and sand the trailing
edge to match the taper of the ribs. Make
sure to leave the bottom part of the tab
attached to rib. This sets the correct
washout for the wing.
26. Locate grooved landing gear blocks (1/2” x
7/8” x 3-7/8”) and drill a 5/32” hole at 90
degrees in the bottom of the landing gear
block groove 3/8” from the end.
25. Using thick CA glue a 3/32” x 1” x 30”
sheet to the trailing edge of the wing flush
with the 1/4” sq. trailing edge.
8
