1.
Installation
AC power installation
Remove the two screws and open the swing door.
Run 3/4” conduit and wiring to the compression fitting on the Control
Enclosure. The AC adaptor in the Control Enclosure is a two pin isolated
adaptor and does not require a ground connection. Connect the neutral
(white) wire to the connector with the white wire already attached.
Connect the hot line (black) to the connector with the black wire. Cap
off the ground (green) wire with the wire nut supplied.
During operation should the unit lose power, the internal backup battery
will power the unit for up to one hour. This battery is charged during
normal operation.
The system should be hooked to the AC power source for an hour
before operation to fully charge the battery.
Interface Cables
There are two cables, each 10’ long. The cable
with
the 8 pin connector connects the Control Enclosure
to
the Display Enclosure. Be sure to turn the locking
collar
tight after installing to insure a solid connection.
The cable with the 4 pin connector connects the
Display to the Horn assembly.
Different cable lengths can be specially ordered.
Содержание Field Pro
Страница 1: ...SkyScan Field Pro Operation Manual...