WWVB time reception takes place from 12:00 am through 6:00 am each day (attempts WWVB reception every
full hour within this time frame). When the time signal is received for example at 1:00 am, the atomic clock will
not attempt to receive the WWVB signal for the remaining hours until 6:00 am. Therefore, the next signal
attempt will take place between 12:00 am and 6:00 am the next day. The other times WWVB reception takes
place, are upon setup and after manual time set exiting mode. Reception is generally not possible during
daylight hours due to the interference of the sun.
YEAR SETTING
The year can be selected sequentially from 2000 to 2049 and will then start over again (default setting 2000).
Only the last 2 digits of the year will be visible on LCD2.
1.
The year digits will start flashing on LCD2. Select the desired year by use of the
+
key.
2.
Press and release the
SET
key to switch to the
“Month Setting”
.
MONTH SETTING
1.
The month digits on LCD2 will start flashing. Set the desired month by use of the
+
key.
2. Press and release the
SET
key to move to the mode
“Date Setting”
.
DATE SETTING
1.
The digits for the date will start flashing on LCD2 (Default setting 1). Set the desired date by use of the
+
key.
Note:
The date can only be set in conjunction with the selected month. For example, it is not possible to set
the date 30 if the month of February is selected.
2.
Press and release the SET key to enter the
“Weekday Setting”
.
WEEKDAY SETTING
1.
The weekday symbols will be displayed on LCD2 in the pre-set language and flashing. Set the desired
weekday by use of the
+
key.
2.
Press and release the
SET
key to enter the mode
“12/24 Hours Time Display Setting”
.
12/24 HOURS TIME DISPLAY SETTING
1. The
“12”
or
“24”
will start flashing in LCD1 (Default setting 12h). Select the desired time display mode by
use of the
+
key.
2.
Press and release the
SET
key to enter the
“ºC/ºF Temperature Setting“
.
°C OR °F TEMPERATURE SETTING
1.
The characters
“°C”
or
“°F”
will start flashing on LCD1 (Default setting °F). By use of the
+
key select
“°C”
for temperature display in degrees Celsius or
“°F”
for degrees Fahrenheit.
2.
Press and release the
SET
key to exit the setting mode and switch back to the normal display mode.
EXIT THE MANUAL SETTING MODES
To return to the normal display mode from anywhere in manual setting mode simply press the
SNZ
key
anytime.
If no keys are pressed for at least 15 seconds in setting mode, the atomic clock will automatically switch
back to normal display mode.
ALARM SETTING
To enter into the alarm setting mode:
1.
Hold the
ALM
key for 4 seconds. The hour digits start flashing.
2.
Press and release the + key to set the hour.
3.
Press and release the
ALM
key to set the minutes. The minute digits start flashing.
4.
Press and release the + key to set the minutes.
5.
Press and release again the
ALM
key to exit the Alarm setting mode or wait for 15 seconds automatic
timeout.
