Skyrush Teryx 450, Инструкция по эксплуатации

Страница: 10 / 24

TERYX Manual
9
6. GET READY FOR FLYING
6.1 GETTING THE MODEL READY
1. Take the TERYX 450 and all accessories out of the packaging.
2. Connect your receiver to the 5in1 unit. The unit comes with 4 labeled servo plugs, which
have to be connected to the receiver. The labels are named so you can easily connect them
to your radio control receiver ports. These are:
AIL – Aileron / Roll (usually port 1)
ELE – Elevator/Pitch (usually port 2)
RUD – Rudder/Yaw (usually port 4)
THR – Throttle/Climb and sink (usually port 3)
The assigning of those control function, but not their direction, are a standard in the rc
industry, it might be necessary that the travel direction of one or several channels must be
inverted. This channel inversion is a basic function of any RC radio control, on basic models
there are switches on the front side which are labeled NOR and INV or REV, on more
sophisticated radio controls the inversion of channels or servo travel direction is part of a
programming menu. Make sure that the levers on your radio control are assigned to the
correct channels, turn off all mixing and swash plate programs. In this manual, the lever
configuration known as Mode 2 (Throttle-Yaw on the left) is the one the further steps refer
to. Please make sure that in other configurations the control responses are different!
3. Charge the batteries. Note: More on charging the batteries and correct handling you will
find at „9. Battery handling and charging” on page 16.
4. Place the fully charged battery in the battery holder so that it can be connected easily to
the helicopter.
Caution! Do not yet connect the battery, the TERYX might take off
uncontrolled.
5. Lift the TERYX 450 up on the balance bar.
6. Move the battery so that the TERYX 450 is hanging leveled. Use
the supplied Velcro to fix the battery in the proper position.
Prior to connecting the battery, you have to connect the
receiver and setup the radio control properly.
7. Caution! The following steps must be carefully executed, so
that your TERYX 450 does not take off as soon as the battery is
connected and the radio control switched on:
. Throttle lever and its trimmer must be in the lowest
position (Motor off);
.
All other levers and trims must be in center position;
8. Turn on the radio control. Caution! In any case switch on the radio control prior to