Skynetic Shrike Glider, Инструкция по эксплуатации

Страница: 4 / 9

STEP 4
Your Skynetic 1400mm Shrike Glider features
an innovative screw-less assembly. This allows
the wing to be attached and removed without
the need for any tools.
First, attach the carbon rod into the left wing
and insert it into the fuselage as shown,
aligning the blue pins.
STEP 5
With both wing halves attached to the fuselage, slide the Wing Pin into the hole as shown. This
pin aligns the interlocking wing halves, and ensures the wings are fastened securely. Always
verify this Wing Pin is fully inserted before each flight. If the Wing Pin is not able to be fully
inserted, reposition the wings until full insertion is achievable.
STEP 6
Before attaching the spinner and propeller, it is imperative that the flight battery is disconnected
from the model and the radio transmitter is powered off.
Fasten the spinner in the sequence shown below. Use a 2.0mm allen key to loosen the two
opposing set screws, then position the black aluminum prop shaft onto the steel motor shaft,
being sure to tighten the set screws directly perpendicular to the flat spots on the motor shaft.
Additional Wing Pins can be
purchased at www.motionrc.com .
Under the Spare Parts tab on the
Skynetic Shrike’s product page,
search for the SKU part number:
SKY1001-107