Skymsen PA-141, Инструкция по эксплуатации

Страница: 12 / 20

4. General Safety Practices
The following safety instructions are addressed to both the operator
of the machine as well as the person in charge of maintenance. The
machine has to be delivered to the operator in perfect conditions of use by
the Distributor to the user. The user shall operate the machine only after
being well acquainted with the safety procedures described in the present
manual. READ THIS MANUAL WITH ATTENTION.
Some parts of the electric devices are connected to high voltage
points. These parts when touched may cause severe electrical shocks or
even be FATAL.
Never touch commands such as buttons, switches and knobs with
wet hands, wet clothes and/or shoes. By not following these instructions
operator could be exposed to severe electrical shocks or even to a FATAL
situation.
The operator has to be well familiar with the position of ON/OFF
Switch to make sure the Switch is easy to be reached when necessary.
Before any kind of maintenance, physically remove plug from the socket.
Provide space for a comfortable operation thus avoiding accidents.
Water or oil spilled on the floor will turn it slippery and dangerous. Make
sure the floor is clean and dry.
Before giving any manual command (switch, buttons, turn keys or
lever) be sure the command is the correct one. Check this manual for
further details if necessary.
Never use a manual command (switch, buttons, lever) unadvisedly.
If any work is to be made by two or more persons, coordination signs will
have to be given for each operation step. Every step of the operation shall
be taken only if the sign has been made and responded.
4.1 Basic Operation Practices
4.1.1 Dangerous parts
4.1.2 Warnings
IMPORTANT
If any item from the GENERAL SAFETY NOTIONS section is not
applicable to your product, please disregard it.
09 26
Problemas Causas Soluções
Contacto malo en el botón
Liga/Desliga
Contacto malo en el enchufe o
en el cable
Llame la asistencia técnica.
Llame el asistente técnico
autorizado.
Corrija la colocación de los
Discos.
Ajuste la tensión de las
correas de acuerdo con
el ítem
5.2.2 deste
manual
Llame el asistente técnico
Llame el asistente técnico
Verifique si el cable no está
interrumpido y controle los
clavillos del enchufe.
Verifique si el enchufe está
en su soquete, y verifique si
hay energía en la red.
Verifique se hay energia
en la red de alimentación.
Enchufe el cable en el
soquete
Ajuste la tensión de las
correas como explicado en
el ítem 5.2.2 deste manual
El disco pára durante la
operación
El procesador no liga
Olor a quemado o humo
La maquina liga, pero hay
demora para que el Disco
comenze a girar
Ruidos anormales
Falta de energía eléctrica
Falta de energía eléctrica
Problema en el motor o en los
circuitos eléctricos.
Falla del condensador de
partida del motor.
Correas patinando
Rodamientos con fallas.
Disco colocado de manera
incorrecta
El enchufe del cable no está
en el soquete
Las correas del motor están
patinando