background image

05

* Control if the filter is placed into its right place inside the Bowl .

*   Fill the Bowl with 30 litres of water .

* Place the lid and tight the loops.   

* After this , put the thermostat handle on 100 C position, and switch 

ON the thermostat . 

* Await one hour,   and let the water flow out through the Outflow 

Faucet .

* Using a clean and wet cloth , dry the Bowl and the Filter.

4.3.1  Advice

When checking the tension of the   belts or chains,   DO NOT introduce 

your fingers between the belts , the chains, nor the gears.

4.3.2  Precautions

Check if motors, belts, chains or gears and the turning or sliding parts   

of the machine produce abnormal noises . 

Check the tension of the   belts and chains and replace the set when 

belt, chain or gears show signs of being worn out.

 

When checking tensions of belts or chain DO NOT introduce your 

fingers between belts and pulleys , nor between the chains and gears. Check 
protections and safety devices to make sure they are working properly.

4.3 Routine Inspection 

4.2 Safety Procedures and Notes Before Turning Machine ON 

IMPORTANT

Carefully read ALL INSTRUCTIONS of this manual before turning the machine 

ON.  Be sure to be familiar with the set and that you have well understood all 

information contained in this manual.  If you have any question contact your 

supervisor or your nearest Dealer.

08

4 .2.1.   Danger
An electric cable or electric wire with damaged insulation could cause electrical 
shocks as well as electrical leak.   Before use check conditions of all wires and 
cables. 

4 .2. 2   Advices
Be sure ALL   INSTRUCTIONS in this manual have been thoroughly understood.   
Every function and operational procedure have to be very clear to the operator.   
Any manual command ( switch, button, or lever ) shall be given only after to be sure it 
is the correct one .

4. 2. 3 Precautions
The electric cable has to be compatible with the power required by the machine,
Cables touching the floor or close to the machine need to be protected against short 
circuits.
Oil reservoirs if any have to be full up to the required level as indicated.   Check level 
and add oil if necessary.

3. OPERATION

3.1 Operation Process

Observation : To start the heating the Bowl shall be full of Water .

* Control the electric installation in accordance with item 2.1.2

* Close the Outflow Faucet .

* Control whether the thermostat handle is placed on 0 C position , and if the 

thermostat, the crushing and the centrifuge command switches are   on position OFF .

* Control if the filter is correctly placed inside the bowl.

* To insert or withdraw the filter use the Filter Handle.

* Next step will depend on the chosen process .

* To start the heating process , place the key on the heating position, and place the 

thermostat handle on the desired temperature .
Observation : only start the heating process with the bowl full of water or other liquid.

    

* Crushing and centrifuge steps may be started without previously go through the 

heating step .

* The command key has four positions , as follows :

     OFF , heating, crushing and centrifuge
     When the key is placed on one of the four position, the chosen position will be
   working , the other three are excluded.

 

Содержание KIT-EPV 30









Отзывы: