14
- Avoid mechanical shocks, once they may cause damages or bad func
ti
oning.
- Avoid water, dirt or dust contact to the mechanical and electrical components of the
machine.
- DO NOT change the standard characteris
ti
cs of the machine.
- DO NOT remove, tear off or maculate any safety or identificati
on labels stuck on the
machine. If any labels have been removed or are no longer legible, contact your nearest
dealer for replacement.
4.2 Safety Procedures and Notes before Switching the Machine ON
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to well understand all the informa
ti
on contained in this manual. If you
have any ques
ti
on contact your supervisor or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insula
ti
on might cause
electrical shocks as well as electrical leak. Before use, check the condi
ti
ons of all wires
and cables.
4.2.2 Advices
Be sure to well understand all the informa
ti
on contained in this manual. Every opera
ti
on
func
ti
on or procedure has to be thoroughly clear.
Before using any commands (switch, bu
tt
ons, lever), be sure it is the correct one. In case
of doubt, consult this manual.
4.2.3 Precau
ti
ons
The electric cable has to be compa
ti
ble with the power required by the machine.
Cables touching the floor or close to the machine need to be protected against short
circuits.
The oil reservoirs have to be filled until the indicated level. Check and refill if necessary.
OBSERVATION
For your own safety read all the machine s
tickers.
11
IMPORTANT
Remove the plug from its socket before to start cleaning.
3.3 Safety System
3.3.1 System avoiding automa
ti
c reset
For mayor operator protec
ti
on this equipment is provided with a safety system not allowing
it to be involuntary switched ON a
ft
er an eventual energy shortage. To reset energy supply
first press the ON/OFF Switch # 08 (Pic.01) to positi
on “O” then to posi
ti
on “I”.
3.4 Cleaning and Sani
ti
zing
IMPORTANT
Do not spray water directly on the equipment
The equipment shall be totally cleaned and sani
ti
zed:
- Before to be used the first ti
me;
- A
ft
er every day opera
ti
on;
- Before to start opera
ti
on a
ft
er a long period without use;
Some parts of the equipment may be removed:
- Cup # 03 (Pic.01);
- Lid # 02 (Pic.01);
- Cap # 01 (Pic.01).
Wash all parts with water and neutral soap.
3.5 Cau
ti
ons with Stainless Steel
The Stainless Steel may present rust signs, which ARE ALWAYS CAUSED BY EXTERNAL
AGENTS, especially when the cleaning or sani
ti
za
ti
on is not constant and appropriate.
The Stainless Steel resistance towards corrosion is mainly due to the presence of chrome,
which in contact with oxygen allows the forma
ti
on of a very thin protec
ti
ve coat. This
protec
ti
ve coat is formed through the whole surface of the steel, blocking the ac
ti
on of
external corrosive agents.
