Skymaster DX 7, Руководство по эксплуатации

Страница: 29 / 32

9. Troubleshooting
GB 29
No antenna signal (No signal display on the unit or via the signal displays in the OSD):
1. Check the antenna cable first: the mesh wire shield and aluminium
insulation must be in contact with the f-plug and should not touch the
cable conductor.
2. Check the LNB settings. For ASTRA satellites LNB1 should be on. If you
use an digital LNB, the lower and upper frequencies have to be 9750 MHz
and 10600 MHz respectively. To trace an error you should connect the LNB
directly to the receiver and first remove the switch and splitter.
Malfunctions 1. The unit displays incorrect broadcasting times in the EPG or the incorrect
time: after the receiver is switched on the data has to be read and
evaluated. Depending on the transponder this process may take some
time. Sometimes it is necessary to call up the EPG again or to switch
channels.
2. No response from the unit: Pull out the power plug and wait a few seconds
before starting the unit again. If the cause is a software error, you can
quickly obtain a software update for the receiver via satellite.
Only a few channels 1. The antenna is aligned to the wrong satellite position. When aligning the
antenna you may be receiving one of numerous satellites, which is
transmitting on a similar frequency and interfering with the receiver's
signal displays. When switching channels foreign stations will often appear
as well as a notification of “No Signal”. It is often enough to turn the
antenna a few degrees to the east or west to receive the channels you
want.
2. Check to see if you have activated the right list of channels. Press
BROWSE to call up the list. Press the
왗
or
왘
buttons to select the channel
list you require (e.g. “All Satellites”).