Note: You must complete the programming sequence within the 15-second interval, otherwise, the
module will quit from programming mode and you need to start again if the red LED is off.
4. Operation
The PR-318 Plug-In Lighting Module allows on / off operation, when the programmed transmitter is
activated.
5. Erasing transmitter
You may erase a transmitter from the Plug-In Lighting Module, but you cannot erase a specific device
directly, you must erase all the wireless devices, the program the ones you want to keep. Follow the
instructions below to erase programmed transmitters.
-
Power off the Plug-In On/Off Control by removing it from
the AC outlet.
-
Press and hold the ‘SET’ button, while plugging in the
Plug-In Control to the AC outlet.
-
The red LED will be on, then flashes rapidly for 1
second.
-
You may release the ‘SET’ button, now you have
successfully erased all the devices.
6. Technical Specification
-
Input Voltage: 120V AC, 60Hz
-
Standby Current: 3mA
-
Maximum Rating: 300W
-
Frequency: 318MHz
-
Range: Up to 300 feet in open area.
WARRANTY
If, within one year from date of purchase, this product should become defective (except battery), due to
faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of purchase and a
Return Authorization are required.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
