6A – Arm Home Sequence:
This setting is used when you wish to secure the area but will be at home and moving around
within the armed area. In Arm Home setting, any motion sensor will not respond to any
movement. Alarm will sound instantly if any of the sensors (e.g. door/window sensor) is
activated (except motion sensor).
-
Pressing the ARM HOME button on the remote will arm the Wireless External Alarm in
Home mode.
-
You will hear 2 beeps and the LEDs will flash twice indicating the Wireless External
Alarm in Home mode.
6B – Arm Away Sequence:
This setting is used when you are the last one to leave the premises. By arming the Wireless
External Alarm in Away mode, you will have 30 seconds to leave the premises after arming.
After 30 seconds, all sensors in the premises are armed. Activating these sensors in Arm Away
mode will result in 30 seconds delay. The alarm will sound if not disarm during the 30 seconds
period.
-
Pressing the ARM AWAY button on the remote will arm the Wireless External Alarm in
Away mode.
-
You will hear 1 beep and the LEDs will flash once indicating the Wireless External Alarm
is being counted to Away mode.
-
After 30 seconds, you will hear 2 beeps and the LEDs will flash twice indicating the
Wireless External Alarm in Away mode.
6C – Disarm
-
Pressing the DISARM button on the remote will disarm the Wireless External Alarm
instantly.
-
You will hear 2 beeps and the LEDs will flash twice indicating the Wireless External
Alarm is disarmed.
6D - Panic
-
Pressing the Panic button on the remote will cause siren instantly.
Note:
-
The Wireless External Alarm cannot be armed if there are triggered sensors. Make sure
all sensors are in closed position, i.e. (close all doors, windows, no movement should be
detected and etc).
-
The Wireless External Alarm can be armed if there are sensors with low battery or failure
warning.
