2b. PROGRAMMING A REMOTE TRANSMITTER TO THE SKYLINK® RECEIVER GB-318
Refer to the receiver Smart Button
TM
GB-
up the unit.
1. Press the learn button on the side of the Smart Button
TM
GB-318.
2. Once the learn button is pressed, the LED will flash quickly. Release
the learn button.
3. Within 30 seconds, press any one of the 3 buttons on the transmitter
that you want to program to the receiver.
4. Once the remote control is programmed, the LED will flash slowly, in
the same way as it flashes in standby mode.
5. You may now operate the garage door opener with this new remote
control.
6. To program this transmitter to control another receiver, repeat
process (1) to (4) to program another button on the remote transmitter.
3. OPERATION
Press the programmed button to open/close the garage door or receiver.
4. BATTERY REPLACEMENT
The remote come with a 3 Volt lithium battery (CR 2032) installed. It is time to change the
battery when the red LED on the transmitter does not turn on when either button is pressed.
To replace the battery:
1. Undo the screw on the back of the remote.
2. Pry out the back cover from the remote
3. Take out the old battery.
4. Place the new battery in position. Be sure the
polarity is correct.
5. Close the back cover with the screw.
Battery Disposal -
Dispose used battery according to local regulation.
5.
WARNING
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired
operation.
changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate the equipment.
